- Two EPDM sealing gaskets
- Uses the same grub-screw continuity system as proven on our Ductile Iron Couplings
- Meets Hydrostatic test pressures
- Couplings in 2-part epoxy finish to match the applicable system
- Suitable for re-use (Gasket should be checked before re-installation for damage/distortion and replaced if necessary)
-
Single-piece casting manufactured from Ductile Iron BS EN 1563 -
Above Ground Ductile Iron Coupling finished externally in a two part red epoxy coating.- Two piece coupling manufactured from ductile iron BS EN 1563
- Zinc plated socket cap locking screw and nut M8 for 50 – 300mm (6mm Allen Drive)
- 2 locking screws on 50 – 100mm and 4 locking screws on 150mm - 300mm dia’s
- EPDM synthetic rubber sealing ring
- Pressure rating up to 0.5 bar unrestrained
- Above ground soil couplings coated in 2 part epoxy finish red colour
-
Below Ground 45° Short Radius Bend finished externally in a two part grey epoxy coating. Code number(s) for available products are: HD4005, HD6005, HD8005, HD10005 & HD12005 All our products are fully compliant with BS EN 877:1999 + A1:2006 Incorporating Corrigendum 2008. -
Above Ground Stainless Steel (Grade 430ti) Coupling.- Clamping unit/collar manufactured from ferritic stainless steel AISI 430 Ti
- 50mm – 150mm: M8 zinc plated socket cap screw and nut (6mm Allen Drive)
- 200mm: M10 zinc plated socket cap screw and nut (8mm Allen Drive)
- EPDM synthetic rubber sealing ring
- Block tightening provides visible torque control
- Pressure rated up to 0.5 bar unrestrained
- Quick Fitting
- Suitable for re-use
- Conforms to the requirements of BS EN 877
-
Below Ground Ductile Iron Coupling finished externally in a two part grey epoxy coating.- Two piece coupling manufactured from ductile iron BS EN 1563
- Zinc plated socket cap locking screw and nut M8 for 100 – 300mm (6mm Allen Drive)
- 2 locking screws on 100mm and 4 locking screws on 150mm - 300mm dia’s
- EPDM synthetic rubber sealing ring
- Pressure rating up to 0.5 bar unrestrained
- Below ground soil couplings coated in 2 part epoxy finish grey colour
-
Above Ground Double Spigot Pipe finished externally in a two part red epoxy coating. For more specifications please see the table below. Code number(s) for available products are: HS2001, HS3001, HS4001, HS6001, HS8001, HS10001 & HS12001 Fully compliant with BS EN 877:1999 + A1:2006 Incorporating Corrigendum 2008. -
Below Ground Double Spigot Pipe finished externally in a two part grey epoxy coating. Code number(s) for available products are: HD4001, HD6001, HD8001, HD10001 & HD12001 All our products are fully compliant with BS EN 877:1999 + A1:2006 Incorporating Corrigendum 2008.